Press "Enter" to skip to content

NEW PRODUCT – STEMMA Wired Potentiometer Breakout Board – 10K ohm Linear

admin 0

from NEW PRODUCT – STEMMA Wired Potentiometer Breakout Board – 10K ohm Linear
by Angelica

4493

NEW PRODUCT – STEMMA Wired Potentiometer Breakout Board – 10K ohm Linear


For the easiest way possible to measure twists, turn to this STEMMA potentiometer breakout (ha!). This plug-n-play pot comes with a JST-PH 2mm connector and a matching JST PH 3-Pin to Male Header Cables – 200mm, so wiring up is a cinch. Simply plug the cable in, then use the black wire to connect to your ground, white wire to the input/signal pin and the red wire to your power pin. The power pin voltage should match the voltage max of your analog input. So, if you’re using a 5V Arduino or compatible, connect red to 5V. If you’re using a 3V Feather board, tie red to 3V.

If you want to connect to something with alligator clips use our STEMMA to Gator cable. To connect to something with a STEMMA 3-pin connector already, use this cable.

4493 iso demo 02 ORIG 2020 01

4493 iso demo 01 ORIG 2020 01

4493 kit quarter ORIG 2020 01

In stock and shipping now!


Internet of Things, Wearable, Sensor and Data Technologies


(Visited 9 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *